3.5" spinner for p51 question?????

Ask Questions about Glow Plugs, Paint, Mounts, etc. here.

Moderator: SteveM

3.5" spinner for p51 question?????

Postby Bubba » Mon Jan 05, 2009 8:27 pm

I just got my order in for a 3.5" spinner, everything looks good and fits. My question is on the back of the aluminum backing plate there are no groves for it to grip but there are in the front, so when I try to tighten the nut the plate spins thus not allowing it to tighten, which even if I were able to tighten it I am afraid it could still spin freely... Is this normal or do I have an incomplete backing plate??
Bubba
 
Posts: 1
Joined: Mon Jan 05, 2009 8:14 pm
Location: West Palm Beach Florida

Postby MECOA » Wed Jan 07, 2009 10:44 am

No there are no grooves on the back side of the spinner plate. The grooves are only on the prop side. You engine prop drive has grooves on it and when tightened it should grip the spinner plate.
MECOA
Site Admin
 
Posts: 1095
Joined: Mon Jun 30, 2003 9:48 pm


Return to K&B/MECOA Accessory Questions

Who is online

Users browsing this forum: No registered users and 9 guests

cron