Post all the small engines stuff here. Cox, Wen-Mac, Testors, Spitzy, Wasp, Holland Hornet, Atwood, Aurora, Gilbert, etc.
Moderators: Frank Klenk, SteveM
by Walt Gifford » Sat Jun 05, 2004 8:57 pm
Does anyone on here make thier own 1/2a engines? I've made 2 rear rotor engines but, want to try a front valve next time.
Giffy
-
Walt Gifford
-
- Posts: 2
- Joined: Sat Jun 05, 2004 8:50 pm
- Location: South Jersey
by Tim Wiltse » Sun Jun 06, 2004 5:48 pm
Giffy,
I have seen your stuff over on the old yahoo group as you know. I have a bunch of ideas for some 1/2a and 1/4a engines. My only problem is lack of machining gear and the know how to run them at this point. I just love rear rotor engines by the way. I am not looking for record beaking power just a powerful nice running engine. I have been looking into a small milling machine to work along side of my small lathe but I just don't know where to start.
Later,
Tim Wiltse
-
Tim Wiltse
-
- Posts: 12
- Joined: Sun Jan 05, 2003 9:30 am
- Location: NC
-
Return to 1/2A and alike
Who is online
Users browsing this forum: No registered users and 18 guests