MECOA's Model Engine Forum & Swap Shop
Ask your technical questions on MECOA-K&B products at the bottom of the main page for factory tech help --- If you are joining as a new member, we must activate your account in efforts keep spammers out.
GMS 47 Leans out and dies
Moderators: Frank Klenk, SteveM
1 post
• Page 1 of 1
GMS 47 Leans out and dies
by Rogo338 » Tue Aug 01, 2006 5:48 pm
After a crash I have reinstalled on a new plane as inverted in a cowl. I replaced the Fuel nipple and tightened all. No matter how I trim in a 2 minute or so it will dead stick. I can't find an airleak and the same will happen in ground testing. :x Maybe the shaft is bent? Bearings fried? [/b]
- Rogo338
- Posts: 1
- Joined: Sun Jul 30, 2006 8:00 pm
- Location: Ill
1 post
• Page 1 of 1
Return to General Engine Tech Talk
Who is online
Users browsing this forum: No registered users and 5 guests