Just the boat engine stuff here
Moderators: Frank Klenk, SteveM
by LIVNPRUF1967 » Tue Nov 15, 2011 12:04 am
I JUST BOUGHT THIS COMPLETE SETUP AND GENTLEMAN THAT BOUGHT AND BUILT IT ALSO ADDED TRIM, IMPRESSED WITH ALL HIS WORK AND ATTENTION FOR DETAIL BUT THE INSTRUCTIONS THE KIT CAME WITH NEITHER SHOWED OR MENTIONED THIS MOD. WOULD I BE SAFE TO REMOVE THE TRIM ADJUSTMENT AND HARD MOUNT THE K&B 7.5 STRAIGHT TO THE BOAT? I ONLY ASK THIS CAUSE IT MAKES NO VISABLE DIFFERANCE OR IMPROVEMENT PROFORMANCE WISE ON THE WATER THAT I CAN NOTICE.
-
LIVNPRUF1967
-
- Posts: 3
- Joined: Mon Nov 14, 2011 11:10 pm
- Location: DENVER, CO
by stagefright » Mon Jan 16, 2012 4:57 pm
You should always have an adjustable motor mount to adjust the boats ride. If not that trim tabs would prolly work 2. I would leave them on if bolting the motor straight to the hull. It might ride low in the water or blow over if not trimmed right.
-
stagefright
-
- Posts: 10
- Joined: Sun Jan 15, 2012 9:19 pm
- Location: PA
Return to Marine Engine Topics
Who is online
Users browsing this forum: No registered users and 6 guests