All outboard, inboard and aero questions answered here.
ALSO Veco, Torpedo, Fury, & Stallion
Moderator: SteveM
by Lee Concannon » Sat Mar 05, 2005 9:11 pm
I have an older Torpedo age unknown 00665 stamped on engine mount the drive hub ( I think thats what it's called ) is 1in. dia. I want to use this on a Zilch Exp. and it calls for a 1 1/2 in spinner. The D.H. is to big to fit on the spinners I have found. Can I have this ground down with out harming anything ? Also the needle valve is to short how can I extend this? Lee
-
Lee Concannon
-
- Posts: 1
- Joined: Sat Mar 05, 2005 8:52 pm
- Location: Moline, Il.
by MECOA » Sat Mar 12, 2005 3:53 pm
Not much to do about the needle unless you solder a piece of brass tube onto it.
As for the prop driver (see
http://www.mecoa.com/faq/terminology/terminology.htm
for the correct terms)
it should be ok to turn it down a little. But do so at your own risk.
-
MECOA
- Site Admin
-
- Posts: 1095
- Joined: Mon Jun 30, 2003 9:48 pm
-
Return to K&B Mfg. Engine Tech Questions
Who is online
Users browsing this forum: No registered users and 99 guests