MECOA's Model Engine Forum & Swap Shop

Ask your technical questions on MECOA-K&B products at the bottom of the main page for factory tech help --- If you are joining as a new member, we must activate your account in efforts keep spammers out.

Skip to content

Bearing problems

All outboard, inboard and aero questions answered here.
ALSO Veco, Torpedo, Fury, & Stallion

Moderator: SteveM

Post a reply

Bearing problems

Postby Sting » Tue Jan 10, 2006 4:19 pm

I am trying to remove PN# 188780 rear crank bearing and pn# 188446 PTO bearing from a K&B 7.5 OB Motor, there is no room to get a puller next to the back of the bearings.

How do you remove them?
Sting
 
Posts: 2
Joined: Tue Jan 10, 2006 4:10 pm
Location: Shen Valley
Top

Postby MECOA » Wed Jan 11, 2006 8:36 pm

You must use a puller and disassemble the bearing. Pull the bearing by the ball groove on the inner race.
MECOA
Site Admin
 
Posts: 1095
Joined: Mon Jun 30, 2003 9:48 pm
Top

Postby Sting » Thu Jan 12, 2006 8:46 am

Got a small chisel between the bearings and then was able to get a small gear puller to work.


Thanks!!
Sting
 
Posts: 2
Joined: Tue Jan 10, 2006 4:10 pm
Location: Shen Valley
Top
Post a reply

Return to K&B Mfg. Engine Tech Questions

Who is online

Users browsing this forum: No registered users and 80 guests

Powered by phpBB® Forum Software © phpBB Group