All outboard, inboard and aero questions answered here.
ALSO Veco, Torpedo, Fury, & Stallion
Moderator: SteveM
by david brooks » Fri Jun 09, 2006 11:37 pm
I took apart my PTO to replace the bearings, how far down should the small collar fit to the bearings? Should this be allowed to have end play? I dont see the part shown anywhere on the explosion drawing. Where is it listed, or just available with an assembly number?
-
david brooks
-
- Posts: 31
- Joined: Wed Jun 07, 2006 3:55 pm
- Location: NW Indiana
by MECOA » Sun Jun 11, 2006 10:36 am
The collar was discontinued a long time ago. It should br pressed down against the bearing. Not too tight, just touching.
-
MECOA
- Site Admin
-
- Posts: 1095
- Joined: Mon Jun 30, 2003 9:48 pm
-
Return to K&B Mfg. Engine Tech Questions
Who is online
Users browsing this forum: No registered users and 74 guests