MECOA's Model Engine Forum & Swap Shop

Ask your technical questions on MECOA-K&B products at the bottom of the main page for factory tech help --- If you are joining as a new member, we must activate your account in efforts keep spammers out.

Skip to content

How do I remove & install the crankshaft & bearings

All outboard, inboard and aero questions answered here.
ALSO Veco, Torpedo, Fury, & Stallion

Moderator: SteveM

Post a reply

How do I remove & install the crankshaft & bearings

Postby fscot » Thu Jun 07, 2007 7:37 am

How do I remove &install the crankshaft & both bearings for a K&B 61?
This question is listed in tech information section but is in black and not blue so I can't click on the question and receive my answer.
fscot
 
Posts: 1
Joined: Thu Jun 07, 2007 7:27 am
Location: Smithfield, NC
Top

Postby MECOA » Tue Jun 12, 2007 2:32 pm

You must heat the crankcase and press the crankshaft out using an arbor press.
MECOA
Site Admin
 
Posts: 1095
Joined: Mon Jun 30, 2003 9:48 pm
Top
Post a reply

Return to K&B Mfg. Engine Tech Questions

Who is online

Users browsing this forum: No registered users and 55 guests

Powered by phpBB® Forum Software © phpBB Group