1. I tore down my K&B 7.5 outboard (8702), and I see some light scoring on one side of the piston and sleeve. Along with the piston and sleeve, should I also replace the wrist pin?
2. When I get up and running I would like to run some 45% Nitro. What head clearance do I need for that?
3. Do you guys sell fuel and glow plugs?
I really appreciate all the help!
MECOA's Model Engine Forum & Swap Shop
Ask your technical questions on MECOA-K&B products at the bottom of the main page for factory tech help --- If you are joining as a new member, we must activate your account in efforts keep spammers out.
What 7.5 parts do I need?
Moderator: SteveM
2 posts
• Page 1 of 1
What 7.5 parts do I need?
by Sohn123 » Fri Jun 29, 2007 5:27 am
- Sohn123
- Posts: 4
- Joined: Thu Jun 14, 2007 6:50 pm
- Location: Duluth, MN
by MECOA » Fri Jul 06, 2007 8:15 am
I can't say about replacing the wrist pin without seeing it. Be sure the teflon pads are good.
also read this
http://www.mecoa.com/faq/squish/squish.htm
no fuel -- glow plugs here
http://www.mecoa.com/acc/glowplug/glowplug.htm
also read this
http://www.mecoa.com/faq/squish/squish.htm
no fuel -- glow plugs here
http://www.mecoa.com/acc/glowplug/glowplug.htm
- MECOA
- Site Admin
- Posts: 1095
- Joined: Mon Jun 30, 2003 9:48 pm
2 posts
• Page 1 of 1
Return to K&B Mfg. Engine Tech Questions
Who is online
Users browsing this forum: No registered users and 61 guests