Can someone help me with instructions for removing the crankshaft? bearings and flywheel?
Thank you!
MECOA's Model Engine Forum & Swap Shop
Ask your technical questions on MECOA-K&B products at the bottom of the main page for factory tech help --- If you are joining as a new member, we must activate your account in efforts keep spammers out.
K&B 11cc, How to remove the crankshaft
Moderator: SteveM
2 posts
• Page 1 of 1
K&B 11cc, How to remove the crankshaft
by Charlottedarter » Sun Nov 25, 2007 6:19 am
- Charlottedarter
- Posts: 5
- Joined: Sat Nov 24, 2007 8:39 pm
- Location: Charlotte, NC
by MECOA » Thu Nov 29, 2007 6:52 pm
Crankshaft must be pressed out the rear of the engine after the piston/cylinder and con rod have been removed. The flywheel or prop driver is just pressed onto a teppered collet and can be pulled off the front with a puller.
- MECOA
- Site Admin
- Posts: 1095
- Joined: Mon Jun 30, 2003 9:48 pm
2 posts
• Page 1 of 1
Return to K&B Mfg. Engine Tech Questions
Who is online
Users browsing this forum: No registered users and 57 guests