All outboard, inboard and aero questions answered here.
ALSO Veco, Torpedo, Fury, & Stallion
Moderator: SteveM
by Green Jumper » Mon Apr 19, 2010 7:42 pm
Hi
I have a new engine - need to obtain a flex-hex to fit. Please confirm output shaft thread.
Thanks
Art
-
Green Jumper
-
- Posts: 22
- Joined: Sat Mar 10, 2007 7:37 am
- Location: Texas
-
by SteveM » Tue Apr 20, 2010 3:27 am
You should take a few minutes to check the MECOA web pages first. Have a look at
http://www.mecoa.com/kb/88/88series.htm for the answer.
-
SteveM
-
- Posts: 242
- Joined: Mon Nov 20, 2006 10:33 am
- Location: Ottawa, Ontario, CANADA
by Green Jumper » Tue Apr 20, 2010 5:16 pm
Hi
Thanks for the tip. I had searched "Marine" info and did not note spec.
In looking at "Car" model info, I note that thread is 5 x .8 mm
Does this apply to Marine version as well?
Please confirm
Thanks Much for your Support!
-
Green Jumper
-
- Posts: 22
- Joined: Sat Mar 10, 2007 7:37 am
- Location: Texas
-
by MECOA » Mon Apr 26, 2010 2:47 pm
5 x .8 for all .18
-
MECOA
- Site Admin
-
- Posts: 1095
- Joined: Mon Jun 30, 2003 9:48 pm
-
by Green Jumper » Mon Apr 26, 2010 5:28 pm
Thanks Very Much for your assistance
Best Regards
Art
-
Green Jumper
-
- Posts: 22
- Joined: Sat Mar 10, 2007 7:37 am
- Location: Texas
-
Return to K&B Mfg. Engine Tech Questions
Who is online
Users browsing this forum: No registered users and 20 guests