All outboard, inboard and aero questions answered here.
ALSO Veco, Torpedo, Fury, & Stallion
Moderator: SteveM
by wrdude » Thu Jul 13, 2006 4:46 am
What front housing should i be ordering for this motor. It has a 15mm crank dia. I'm going by pictures and come up with the 31-8722 only because it has front intake rear exhaust and says 15 mm crank.
-
wrdude
-
- Posts: 9
- Joined: Mon May 08, 2006 5:45 am
by MECOA » Sat Jul 15, 2006 4:54 pm
This is the correct hsg but it uses a draw bar to hold the carburetor, not 2 screws. So if you are replacing one with 2 scres you will also need the draw bar.
-
MECOA
- Site Admin
-
- Posts: 1095
- Joined: Mon Jun 30, 2003 9:48 pm
-
by wrdude » Mon Jul 17, 2006 2:04 pm
It shows 2 different housings in the exploded view and the one for the 15mm crank shows 2 screws.
-
wrdude
-
- Posts: 9
- Joined: Mon May 08, 2006 5:45 am
by MECOA » Wed Jul 19, 2006 8:00 am
Actually the one shown in the diagram is wrong. Both 15 and 17 mm use drw bars. The mold was changed long ago and none with the screw mounting are available.
-
MECOA
- Site Admin
-
- Posts: 1095
- Joined: Mon Jun 30, 2003 9:48 pm
-
Return to K&B Mfg. Engine Tech Questions
Who is online
Users browsing this forum: No registered users and 107 guests